USB Endpoint converter board allows to connect any equipment with E1 (G.703) / Stanag / Eurocom interfaces
to any equipment with USB interface. Converters comes in following versions:
USB Endpoint raw data adapter
The converters allows to transmit/receive E1 (G.703) / STANAG4210 / Eurocom (D/1 and EES) raw streams and transfer them directly to any
device via Host USB 1.0 interface. Linux device driver is provided, allowing rapid application developement.
USB Endpoint E1 framing adpater
The converter allows to transmit/receive E1 (G.703) stream and transfer it to directly to any device via Host USB 1.1 interface.
The adapter supports G.704/G.706 (framing) and HDLC protocol establishement on dedicated timeslot. Seperate retrieval of
data from each timeslot is supported. Two E1 trunks are supported on a board with single USB 1.1 interface.
Linux device driver is provided, allowing rapid application developement.
USB Endpoint Eurocom framing adpater
The converter allows to receive Eurocom D/1 stream (256..1024kbit/s) and transfer it to directly to any device via Host USB 1.1 interface.
The adapter supports Eurocom Trunk Group (IB) and Loop Group (IC): interconnection points B/C (IB6.3 and IB5.2), framing (IB3), signalling with error correction (IB4) and CVSD/PCM conversion (IA8). Seperate retrieval of data from each timeslot is supported.
Two Eurocom trunks (up to 60 channels) are supported on a board with single USB 1.1 interface.
Linux device driver is provided, allowing rapid application developement.
USB Endpoint STANAG 4206 framing adpater
The converter allows to receive STANAG 4206 stream (256..1024kbit/s) and transfer it to directly to any device via Host USB 1.1 interface.
The adapter supports Stanag Trunk: phisical interface (STANAG 4210), framing (STANAG 4207), signalling with error correction (STANAG 4208)
and CVSD/PCM conversion (STANAG 4209). Seperate retrieval of data from each timeslot is supported.
Two STANAG trunks (up to 60 channels) are supported on a board with single USB 1.1 interface.
Linux device driver is provided, allowing rapid application developement.
Additional resources
Please refer to following resources on our site (section
TECHNOLOGIES
), to learn more about E1, Stanag and Eurocom interfaces.